|
|
|
National Stock Number:
5905-01-274-7854
Federal Supply Class:
5905
National Item Identification Number:
012747854
Description:
RESISTOR,FIXED,FILM
Detail:
A resistor whose ohmic value cannot be adjusted or varied. The resistance element consists of either a thin layer of conductive material, containing either binders or insulating materials, deposited on an insulated form; or an alloy of metal and ceramic materials, usually fused to an insulated form. Opposition to the flow of current is an inherent property of the materials used and is manifest by the heat dissipation in the resistor. See also ATTENUATOR, FIXED and RESISTOR, FIXED, COMPOSITION. Excludes carbon composition type resistors.
|
Manufacturer Information:
| 10131087 | A486G | NIMIKKEISTOKESKUS NCB FINLAND | | 5R9720-002-1183 | 56235 | STATE OF THE ART, INC. | | M55342K04B118ER | 56235 | STATE OF THE ART, INC. | | 5R9720-002-1183 | 73030 | HAMILTON SUNDSTRAND CORPORATION | | M55342K04B118ER | 91637 | VISHAY DALE ELECTRONICS, LLC | | RCWP-5150-9-11802F | 91637 | VISHAY DALE ELECTRONICS, LLC |
|
Techincal Specification:
| ELECTRICAL RESISTANCE | 118.000 KILOHMS | | AMBIENT TEMP AT FULL RATED POWER | 70.0 CELSIUS | | AMBIENT TEMP IN DEG CELSIUS AT ZERO PERCENT RATED POWER | 125.0 | | BODY HEIGHT | 0.010 INCHES MINIMUM AND 0.040 INCHES MAXIMUM | | BODY LENGTH | 0.145 INCHES MINIMUM AND 0.175 INCHES MAXIMUM | | BODY WIDTH | 0.045 INCHES MINIMUM AND 0.060 INCHES MAXIMUM | | INCLOSURE TYPE | UNINCLOSED | | POWER DISSIPATION RATING IN WATTS | 0.150 FREE AIR | | RELIABILITY FAILURE RATE LEVEL IN PERCENT | 0.010 | | RELIABILITY INDICATOR | ESTABLISHED | | RESISTANCE TOLERANCE IN PERCENT | -1.000 TO 1.000 | | UNPACKAGED UNIT WEIGHT | 0.0001 GRAMS | | STYLE DESIGNATOR | TERMINATION PAD EACH END | | TEMP COEFFICIENT OF RESISTANCE IN PPM PER DEG CELSIUS | -100.0 TO 100.0 | | TEMP RANGE OF TEMP COEFFICIENT IN DEG CELSIUS | -65.0 TO 125.0 | | TERMINAL TYPE | TERMINAL TYPE PER BODY STYLE | | TEST DATA DOCUMENT | 73030-5R9720-002 DRAWING (THIS IS THE BASIC GOVERNING DRAWING, SUCH AS A CONTRACTOR DRAWING, ORIGINAL EQUIPMENT MANUFACTURER DRAWING, ETC.; EXCLUDES ANY SPECIFICATION, STANDARD OR OTHER DOCUMENT THAT MAY BE REFERENCED IN A BASIC GOVERNING DRAWING) |
|
|