|
|
|
National Stock Number:
5315-01-361-3456
Federal Supply Class:
5315
National Item Identification Number:
013613456
Description:
PIN,GROOVED,HEADLESS
Detail:
A headless item of various shapes, usually cylindrical, having either circular or longitudinal groove(s). Its length must not exceed 12 inches (304 MM). Excludes ROD, GROOVED, HEADLESS; SHAFT (as modified); and PIN, VEHICULAR LEAF SPRING SHACKLE.
|
Manufacturer Information:
| 183196-1 | 71791 | CURTISS-WRIGHT CONTROLS, INC. |
|
Techincal Specification:
| EFFECTIVE LENGTH | 1.222 INCHES MINIMUM AND 1.222 INCHES MINIMUM AND 1.238 INCHES MAXIMUM1.238 INCHES MAXIMUM | | DIAMETER | 0.2487 INCHES MINIMUM AND 0.2487 INCHES MINIMUM AND 0.2491 INCHES MAXIMUM0.2491 INCHES MAXIMUM | | FIRST END STYLE | CHAMFEREDCHAMFERED | | FIRST END LOCATION | BOTH ENDSBOTH ENDS | | FIRST END TAPER ANGLE | 42.5 DEGREES MINIMUM AND 42.5 DEGREES MINIMUM AND 47.5 DEGREES MAXIMUM47.5 DEGREES MAXIMUM | | FIRST END TAPER LENGTH | 0.020 INCHES MINIMUM AND 0.020 INCHES MINIMUM AND 0.040 INCHES MAXIMUM0.040 INCHES MAXIMUM | | OVERALL LENGTH | 1.465 INCHES MINIMUM AND 1.465 INCHES MINIMUM AND 1.475 INCHES MAXIMUM1.475 INCHES MAXIMUM | | SECOND END RELATIONSHIP WITH FIRST END | IDENTICALIDENTICAL | | SECOND UNDERCUT WIDTH | 0.031 INCHES MINIMUM AND 0.031 INCHES MINIMUM AND 0.034 INCHES MAXIMUM0.034 INCHES MAXIMUM | | STYLE DESIGNATOR | GROOVEGROOVE | | SPECIAL FEATURES | SHOT PEEN PER MIL-S-13165 USE S-170 SIZE HARD SHOT (RC 55-65) TO AN INTENSITY OF .012-.015A. 200 PERCENT COVERAGE REQUIRED. 100 PERCENT TO BE DETERMINED BY VISUAL EXAMINATION AT 10 TIMES MAGNIFICATION. PEENING PROCEDURE MUST BE APPROVED BY CWFS ENGINEERING. DIMENSIONS APPLY BEFORE SHOT PEENING,PLATING AND AFTER HEAT TREAT. PEEN TO WITHIN .120-.150 OF BOTH ENDS. ITEM IS CADMIUM PLATED OR CHROMATE TREATMENTSHOT PEEN PER MIL-S-13165 USE S-170 SIZE HARD SHOT (RC 55-65) TO AN INTENSITY OF .012-.015A. 200 PERCENT COVERAGE REQUIRED. 100 PERCENT TO BE DETERMINED BY VISUAL EXAMINATION AT 10 TIMES MAGNIFICATION. PEENING PROCEDURE MUST BE APPROVED BY CWFS ENGINEERING. DIMENSIONS APPLY BEFORE SHOT PEENING,PLATING AND AFTER HEAT TREAT. PEEN TO WITHIN .120-.150 OF BOTH ENDS. ITEM IS CADMIUM PLATED OR CHROMATE TREATMENT | | UNDERCUT DIAMETER | 0.2285 INCHES MINIMUM AND 0.2285 INCHES MINIMUM AND 0.2315 INCHES MAXIMUM0.2315 INCHES MAXIMUM | | UNDERCUT WIDTH | 0.031 INCHES MINIMUM AND 0.031 INCHES MINIMUM AND 0.034 INCHES MAXIMUM0.034 INCHES MAXIMUM |
|
|