5305-00-407-5472, SCREW,CLOSE TOLERANCE

5905-00-407-5473 RESISTOR,FIXED,WIRE WOUND

National Stock Number:
5305-00-407-5472

Federal Supply Class:
5305

National Item Identification Number:
004075472

Description:
SCREW,CLOSE TOLERANCE

Detail:
A SCREW, MACHINE or SCREW, CAP, SOCKET HEAD whose unthreaded portion is of specified grip length, plated or unplated, and is machined to a tolerance of one thousandth (0.001 IN.) (0.025 mm) or less of a specific diameter for items (1.000 IN.) (25 mm) or less in diameter. Items over (1.000 IN.) (25 mm) in diameter shall have a tolerance of fifteen ten thousandths (0.0015 IN.) (0.038 mm) or less. The nominal major diameter of the threads shall be at least one thousandth (0.001 IN.) (0.025 mm) below the minimum shank diameter, but not below the minimum major diameter for applicable class of fit, as shown in the Screw Thread Standards, FED STD H28 and/or other nationally recognized standards. The head is designed to be held or driven with an inserted driver. It is not designed for rotation by the thumb and fingers. A locking feature may be incorporated in the design of the head or threads.

Manufacturer Information:

AIC793-5-30	06725	SPS TECHNOLOGIES, LLC
C793-5-30	81755	LOCKHEED MARTIN CORPORATION
VS2545T5F30T	06950	HOWMET GLOBAL FASTENING SYSTEMS INC
SFT22-5-30	56878	SPS TECHNOLOGIES, LLC
SFT22-5-30	80539	SPS TECHNOLOGIES, LLC
VS2545T5F30T	92215	HOWMET GLOBAL FASTENING SYSTEMS INC

Techincal Specification:

DISTANCE FROM HEAD LARGEST BEARING SURFACE TO SHANK HOLE CENTER	2.100 INCHES MINIMUM AND 2.130 INCHES MAXIMUM FIRST HOLE
COUNTERSINK ANGLE	99.0 DEGREES MINIMUM AND 101.0 DEGREES MAXIMUM
FASTENER LENGTH	2.210 INCHES MINIMUM AND 2.257 INCHES MAXIMUM
GRIP DIAMETER	0.3108 INCHES MINIMUM AND 0.3117 INCHES MAXIMUM
GRIP LENGTH	1.865 INCHES MINIMUM AND 1.885 INCHES MAXIMUM
HARDNESS RATING	46.0 ROCKWELL C MINIMUM AND 50.0 ROCKWELL C MAXIMUM OVERALL
HEAD DIAMETER	0.630 INCHES NOMINAL
HEAD STYLE	FLAT COUNTERSUNK
INTERNAL DRIVE STYLE	OFFSET CRUCIFORM (TORQUE SET)
MATERIAL DOCUMENT AND CLASSIFICATION	AMS6485 ASSN STD SINGLE MATERIAL RESPONSE OVERALL
MATERIAL	STEEL COMP H11 OVERALL
MINIMUM TENSILE STRENGTH	220000 POUNDS PER SQUARE INCH
NOMINAL THREAD DIAMETER	0.312 INCHES
SHANK UNTHREADED HOLE DIAMETER	0.066 INCHES MINIMUM AND 0.086 INCHES MAXIMUM FIRST HOLE
SURFACE TREATMENT DOCUMENT AND CLASSIFICATION	NAS 672 ASSN STD SINGLE TREATMENT RESPONSE OVERALL
SURFACE TREATMENT	CADMIUM OVERALL
THREAD CLASS	3A
THREAD DIRECTION	RIGHT-HAND
THREAD LENGTH	0.325 INCHES MINIMUM AND 0.392 INCHES MAXIMUM
THREAD QUANTITY PER INCH	24
THREAD SERIES DESIGNATOR	UNIFIED NATIONAL JOINT FINE (UNJF)

Click here to Register for Free 30-day Trial