| END CONNECTION DESIGN | STRAIGHT FIRST END |
| END FITTING COMPONENT AND MATERIAL | NIPPLE ALUMINUM ALLOY ALL ENDS |
| END FITTING COMPONENT AND MATERIAL | NUT STEEL FIRST END |
| BURST TEST PRESSURE | 16000.0 POUNDS PER SQUARE INCH |
| CONNECTION STYLE | SWIVEL NUT FLARE FIRST END |
| CONNECTION TYPE | THREADED INTERNAL TUBE FIRST END |
| CROSS-SECTIONAL SHAPE STYLE | ROUND |
| FITTING COMPONENT AND SURFACE TREATMENT | NUT CADMIUM FIRST END |
| FITTING COMPONENT AND SURFACE TREATMENT | NIPPLE ANODIZE ALL ENDS |
| HYDROSTATIC TEST PRESSURE | 8000.0 POUNDS PER SQUARE INCH |
| INSIDE DIAMETER | 0.212 INCHES MINIMUM AND 0.244 INCHES MAXIMUM |
| INSIDE SURFACE CONDITION | SMOOTH |
| LAYER COMPOSITION AND LOCATION | 1ST LAYER BRAIDED STEEL WIRE AND 2ND LAYER BRAIDED STEEL WIRE AND 3RD LAYER BRAIDED COTTON CORD AND OUTER LAYER MOLDED RUBBER |
| OPERATING PRESSURE | 3000.0 POUNDS PER SQUARE INCH (PSI) MAXIMUM LOCATION NOT OTHERWISE SPECIFIED |
| OUTER COVERING ENVIRONMENTAL PROTECTION | ABRASION RESISTANT AND OIL RESISTANT |
| OUTSIDE DIAMETER | 0.594 INCHES MINIMUM AND 0.656 INCHES MAXIMUM |
| MEASURING METHOD AND LENGTH | 14.500 INCHES NOMINAL WORKING |
| MEDIA FOR WHICH DESIGNED | HYDRAULIC FLUID, PHOSPHATE-ESTER BASE SINGLE RESPONSE |
| MINIMUM INSIDE BENDING RADIUS | 3.000 INCHES |
| NOMINAL THREAD SIZE | 0.438 INCHES FIRST END |
| SEAT ANGLE | 37.0 DEGREES FIRST END |
| SPECIAL FEATURES | INNER CONVEYING TUBE MATERIAL-RUBBER, SYNTHETIC; NIPPLE-ADDITIONAL MATERIAL STEEL,NIPPLE-ADDITIONAL SURFACE TREATMENT CADMIUM QQ-P-416 TYPE 1 CLASS 2 |
| SPECIFICATION/STANDARD DATA | 96906-MS28759 GOVERNMENT STANDARD |
| TEMP RATING | -65.0 FAHRENHEIT AND 200.0 FAHRENHEIT SINGLE RESPONSE |
| THREAD CLASS | 3B FIRST END |
| THREAD DIRECTION | RIGHT-HAND FIRST END |
| THREAD SERIES DESIGNATOR | UNIFIED NATIONAL JOINT FINE (UNJF) FIRST END |