| MATERIAL | STEEL COMP E52100 INNER RING |
| STEEL COMP E52100 OUTER RING |
| STEEL COMP 4140 OUTSIDE WASHERS |
| COPPER ALLOY RETAINER |
| STEEL COMP E4340 ROD END BODY |
| STEEL COMP E52100 ROLLER |
| RUBBER BUTADIENE-ACRYLONITRILE CLASS NBR SEAL |
| STEEL COMP 4140 SLEEVE |
| MATERIAL DOCUMENT AND CLASSIFICATION | AISI ASSN STD SINGLE MATERIAL RESPONSE INNER RING |
| AISI ASSN STD SINGLE MATERIAL RESPONSE OUTER RING |
| AISI ASSN STD SINGLE MATERIAL RESPONSE OUTSIDE WASHERS |
| MIL-S-5000 MIL SPEC SINGLE MATERIAL RESPONSE ROD END BODY |
| AISI ASSN STD SINGLE MATERIAL RESPONSE ROLLER |
| AISI ASSN STD SINGLE MATERIAL RESPONSE SLEEVE |
| SURFACE TREATMENT | CADMIUM ALL EXTERNAL/EXPOSED METAL SURFACES |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-416,TYPE 1,CLASS 2 FED SPEC SINGLE TREATMENT RESPONSE ALL EXTERNAL/EXPOSED METAL SURFACES |
| STYLE DESIGNATOR | DOUBLE ROW, CONCAVE ROLLERS |
| SELF-ALIGNMENT ANGLE | 8.00 DEGREES NOMINAL |
| OVERALL LENGTH | 5.7650 INCHES NOMINAL |
| BORE DIAMETER | 0.7500 INCHES NOMINAL |
| OUTER RING WIDTH | 0.8750 INCHES NOMINAL |
| INNER RING WIDTH | 1.2500 INCHES NOMINAL |
| LENGTH FROM BORE CENTER TO SHANK END | 4.5000 INCHES NOMINAL |
| SHANK STYLE | EXTERNALLY THREADED |
| SHANK DIAMETER | 0.7500 INCHES NOMINAL |
| SHANK THREAD LENGTH | 2.5500 INCHES MINIMUM AND |
| 2.5700 INCHES MAXIMUM |
| THREAD SERIES DESIGNATOR | UNJF |
| NOMINAL THREAD SIZE | 0.750 INCHES |
| THREAD QUANTITY PER INCH | 16 |
| THREAD CLASS | 3A |
| THREAD DIRECTION | RIGHT-HAND |
| RETAINER FABRICATION METHOD | MACHINED |
| SEAL QUANTITY | 2 |
| BEARING SEAL TYPE | CONTACT |
| ALIGNMENT TYPE | SELF-ALIGNING |
| SELF-ALIGNMENT LOCATION | INTERNAL |
| INTERNAL FIT-UP DESIGNATION | STANDARD |
| TEST DATA DOCUMENT | 36659-LCP72-1076 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| SPECIAL FEATURES | PLATING ON BEARING ONLY |
| LUBRICATION MATERIAL | GREASE |