| ALIGNMENT TYPE | RIGID |
| BEARING SEAL TYPE | CONTACT |
| LUBRICATION MATERIAL DOCUMENT AND CLASSIFICATION | MIL-G-81322 MIL SPEC SINGLE MATERIAL RESPONSE |
| LUBRICATION MATERIAL | GREASE |
| MATERIAL | PLASTIC POLYAMIDE (NYLON) AND MOLYBDENUM SEAL |
| MATERIAL | STEEL END PLATE |
| MATERIAL | STEEL OUTER RING |
| MATERIAL | STEEL ROLLER |
| MATERIAL | STEEL STUD |
| NOMINAL THREAD SIZE | 0.4375 INCHES |
| OUTER RING WIDTH | 0.4950 INCHES MINIMUM AND 0.5000 INCHES MAXIMUM |
| OVERALL LENGTH | 1.3750 INCHES MINIMUM AND 1.4063 INCHES MAXIMUM |
| OVERALL OUTSIDE DIAMETER | 0.7495 INCHES MINIMUM AND 0.7510 INCHES MAXIMUM |
| SEAL QUANTITY | 2 |
| SPECIAL FEATURES | STEEL OIL HOLE PLUG ROLLER END |
| STANDARD TOLERANCE DESIGNATION | AFBMA STD TOLERANCE FOR CAN FOLLWER NEEDLE BEARING |
| STUD DIAMETER | 0.4355 INCHES MINIMUM AND 0.4370 INCHES MAXIMUM |
| STUD LENGTH | 0.8437 INCHES MINIMUM AND 0.9062 INCHES MAXIMUM |
| STYLE DESIGNATOR | CAM FOLLOWER |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-C-320,CLASS 2 FED SPEC SINGLE TREATMENT RESPONSE OUTER RING OUTSIDE DIAMETER |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-416,TYPE 1,CLASS 2 FED SPEC SINGLE TREATMENT RESPONSE EXPOSED SURFACES OF STUD AND WASHER AS MOUNTED |
| SURFACE TREATMENT | CADMIUM EXPOSED SURFACES OF STUD AND WASHER AS MOUNTED |
| SURFACE TREATMENT | CHROMIUM OUTER RING OUTSIDE DIAMETER |
| THREAD LENGTH | 0.3750 INCHES NOMINAL |
| THREAD CLASS | 3A |
| THREAD DIRECTION | RIGHT-HAND |
| THREAD QUANTITY PER INCH | 20 |
| THREAD SERIES DESIGNATOR | UNIFIED NATIONAL JOINT FINE (UNJF) |