|
|
|
National Stock Number:
3040-01-185-5385
Federal Supply Class:
3040
National Item Identification Number:
011855385
Description:
SHAFT,STRAIGHT
Detail:
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for jubricating holes. For items having an integral gear(s) or worm(s), see GEARSHAFT (as modified). For items designed to support rotating members see AXLE(1), STRAIGHT. For items not having the above conditions see PIN, STRAIGHT, HEADLESS. For items having machined ends which constitute steps see SHAFT(1), SHOULDERED; AXLE(1), SHOULDERED; and BOLT, FLUID PASSAGE.
|
Manufacturer Information:
| 10900574 | 19207 | U S ARMY TANK AUTOMOTIVE COMMAND AMSTA-IM-MM | | 328-775X | 11757 | PARKER HANNIFIN CORPORATION | | 9P-20 | 11757 | PARKER HANNIFIN CORPORATION |
|
Techincal Specification:
| END SIMILARITY | NOT IDENTICAL | | FIRST END DISTANCE FROM HOLE CENTER TO END | 2.094 INCHES NOMINAL | | FIRST END DIAMETER | 1.2495 INCHES MINIMUM AND 1.2500 INCHES MAXIMUM | | FIRST END STYLE | THREADED CROSS DRILLED (THRU HOLE) | | MATERIAL DOCUMENT AND CLASSIFICATION | QQ-S-624 FED SPEC SINGLE MATERIAL RESPONSE | | MATERIAL | STEEL | | OVERALL LENGTH | 7.125 INCHES NOMINAL | | SECOND END GROOVE DIAMETER | 0.7490 INCHES MINIMUM AND 0.7500 INCHES MAXIMUM | | SECOND END GROOVE WIDTH | 0.0730 INCHES NOMINAL | | SECOND END DIAMETER | 1.2495 INCHES MINIMUM AND 1.2500 INCHES MAXIMUM | | SECOND END DISTANCE FROM END TO GROOVE | 0.437 INCHES NOMINAL | | SECOND END SPLINE LENGTH | 0.7490 INCHES MINIMUM AND 0.7500 INCHES MAXIMUM | | SECOND END SPLINE MAJOR DIAMETER | 1.2495 INCHES MINIMUM AND 1.2500 INCHES MAXIMUM | | SECOND END SPLINE MINOR DIAMETER | 1.0230 INCHES MINIMUM AND 1.0800 INCHES MAXIMUM | | SECOND END SPLINE QUANTITY | 10 | | SECOND END STYLE | CIRCULAR GROOVED AND SPLINED (STRAIGHT) | | SPECIAL FEATURES | SECOND END HAS PARIAL BORE WITH UNTHREADED 0.156 INCH DIAMETER LOCATED ON ONE SIDE | | SURFACE FINISH | 16.0 MICROINCHES |
|
|