|
|
|
National Stock Number:
3040-00-923-2385
Federal Supply Class:
3040
National Item Identification Number:
009232385
Description:
SHAFT,STRAIGHT
Detail:
A straight shaft having two or more of the following conditions: a specified surface finish designation in the range of 1 to 125 microinches (o.o25 to 3.2 micrometers), arithmetical average (aa), machined peripheral flat(s), circular groove (s), keyway(s), splines, threads, or holes. It is not designed for use in aligning by fitting into corresponding holes of another item. It may be drilled for jubricating holes. For items having an integral gear(s) or worm(s), see GEARSHAFT (as modified). For items designed to support rotating members see AXLE(1), STRAIGHT. For items not having the above conditions see PIN, STRAIGHT, HEADLESS. For items having machined ends which constitute steps see SHAFT(1), SHOULDERED; AXLE(1), SHOULDERED; and BOLT, FLUID PASSAGE.
|
Manufacturer Information:
| 6829430 | 63005 | ROLLS-ROYCE CORPORATION | | 6829430 | 73342 | ALLISON TRANSMISSION INC |
|
Techincal Specification:
| END SIMILARITY | NOT IDENTICAL | | FIRST END DIAMETER | 0.4350 INCHES MINIMUM AND 0.4360 INCHES MAXIMUM | | FIRST END SLOT DEPTH | 0.240 INCHES NOMINAL | | FIRST END SLOT WIDTH | 0.093 INCHES NOMINAL | | OVERALL LENGTH | 1.850 INCHES NOMINAL | | MATERIAL DOCUMENT AND CLASSIFICATION | AMS4842 ASSN STD SINGLE MATERIAL RESPONSE | | MATERIAL | COPPER ALLOY | | SECOND END DIAMETER | 0.4350 INCHES MINIMUM AND 0.4360 INCHES MAXIMUM | | SECOND END HOLE DIAMETER | 0.0620 INCHES NOMINAL | | SECOND END DISTANCE FROM HOLE CENTER TO END | 0.019 INCHES NOMINAL | | SECOND END STYLE | UNTHREADED CROSS DRILLED | | SURFACE FINISH | 32.0 MICROINCHES | | TEST DATA DOCUMENT | 73342-MIL-Q-9858 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
|
|